Mircom TX3 Series Guida Utente Scaricare il pdf (Pagina 22)

22 (61) TX3-CX Card Access System Installation and Operation Manual Version 2.2

Configurable Features

• an access card with lock/unlock privileges, if swiped twice in succession,

toggles between lock and unlock mode

• a schedule associated with the lock/unlock mode - when the associated

schedule is active, it changes to unlock mode and when the schedule is

inactive, it changes back to lock mode

Whenever the mode is changed from lock to unlock or from unlock to lock, the

beeper on the reader associated with this access point sends a distinct beep

indicating the mode is changed.

2.3.2 High security

The high security mode grants access to cards with the high security privilege.

This mode is changed as follows.

• if the access point is configured as high security then it is in high security

mode by default unless changed by the PC or card with high security

privilege

• if an access card with high security privilege is swiped four times in

succession, the mode toggles between high security on to high security off

• the configurator software can change the mode from high security on to

high security off or from high security off to high security on

• an event correlated with a response to turn on or off the high security mode

The high security mode locks all doors in the unlocked mode.

Whenever the high security mode changes, the beeper on the reader associated

with this access point sends a distinct beep.

2.3.3 PC decision required

During this mode the decision to grant access is transferred to an attendant. Using

the PC the attendant grants or denies access. Only valid cards assigned with the

PC decision requirement are able to make this type of access request.

2.3.4 Facility code mode

Access cards consist of two codes; facility code and card code. The facility code

mode is designed for new installations where access cards are not programmed

into the database. When the facility code mode is enabled, cards with same

facility code are granted access.

The facility code can be set to any number. If a number is not chosen, it will

automatically default to “0” as a placeholder.

In this mode, the door is unlocked for the same period of time that as that of the

standard door unlock timer. This mode is configured for each access point.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 60 61

Nessun commento

Mircom TX3 Series Guida Utente Pagina 22